DisplayIT + Infrared Wireless in Car Reciever Includes Beacon

DisplayIT + Infrared Wireless in Car Reciever Includes Beacon

larger image

$599.00

DISPLAY IT & TRANSMITTER BEACON & INFRARED RECEIVER KIT

BAPX-HUD9X-34-IRW-B

DISPLAY IT

At any event where the timing is done with an up to date AMB timing system, you can use the BAPX DisplayIT. You never have to worry about setting up an infrared beacon or adjusting the infrared reciever on your car. The AMB DisplayIT gets its information directly from the AMB timing system, so no additional equipment is needed. Just plug in the DisplayIT in a 12V source, and you are ready to go. It doesn't get any easier than that...

DisplayIt: The Ultimate Laptimer

No beacons to setup in the pits or near the track
Official laptimes direct from the AMB timing system
Uses your AMB Personal Transponder number
Powered from your vehicle's power source (9V to 14V)
Water Resistant
Easy to read, yet fits on a steering wheel

Essential Race Data You Crave

Offical AMB Laptimes
Gap with your best time
Current Overall Position (based on all laptimes on the track)
Gap with Car Ahead (in seconds)
Total laps made in session
Track Time (time on track of session)

TRANSMITTER BEACON

The infrared transmitter will trigger the infrared receiver to allow the DisplayIT in-car lap timer to function without the need for an AMB transponder and special hardware in the timing tower. The infrared receiver is required.This transmitter will also trigger AIM infrared receivers.

Beacon Specifications

Infrared link: PCM modulated infrared transmitter
Range: Approximately 60' depending on weather conditions and proper mounting angle
Required voltage: 7 - 24V
Power consumption: 1W (0.09A @ 12V) Requires external battery
Polarity of DC connector: No polarity (diode rectified). Power cord included with alligator clips
Dimensions: 4.75" x 3.25" x 1" (LxWxH)
Casing material: ABS-PC, waterproof design
Mounting method: 1/4"-20 thread at the bottom (regular camera mount)

INFRARED RECEIVER

The infrared receiver enables the DisplayIT in-car lap timer to function without the need for an AMB transponder and special hardware in the timing tower.The receiver will detect a track-side beacon (infrared transmitter) and will relay the timing information to the DisplayIT wirelessly.The beacon can be a Blind Apex infrared transmitter or an AIM infrared beacon.